Super hydrophobic effect and protection from water, dust, salt and UV-rays.
Increased protection against scratches.
Extra hard ceramic self-cleaning rims’ protection.
It is also resistant to high temperatures created during braking.

The fastest way for permanent protection of every kind of rims: both painted and polished.
It gives a superb hydrophobic effect that lasts for months.

How to apply the product:
1 Shake bottle well before use and wait 3 minutes before opening.
2 Wrap small cloth around soft-side of the applicator.
3 Apply few drops of R1 onto applicator covered with small cloth.
4 Apply thin and even layer onto rim.
5 Leave the layer on the surface for approx. 7-8 minutes (bonding time).
6 Buff the surface with microfiber towel to a high gloss.
7 Move to next paintwork section. Attention: Do not apply R1 to hot surfaces or in direct sunlight.

It is good to know that:
If you want to know if the product is ready to buff, first try to move a hanging towel over drying coating.
If the towel slides easily then wait a few minutes until the surface will start to slow it down.

For best results put up to 3 layers of the product with minimum time interval of 3 hours.

What you need to know:
1 Use thin rubber protective gloves.
2 Apply indoor only with temperature of 18-24 C.
3 Make sure the surface is clean and cool.
4 Degrease and remove old coatings from the glass before application.
5 Apply additional layers with minimum time interval of 3 hours.
6 Drying time after application of last layer – 8 hours.
7 Do not expose the car to water for 24 hours after coating.